US New Hampshire DMV CDL Combination Vehicles Test 2

DMV & CDL » Category

Author: TestGru Team (Education Specialist)

20 questions · All questions on one page

Prepared with up-to-date content

DMV New Hampshire — Cdl Combination DMV — New Hampshire (USA, State Traffic Law) USA — New Hampshire State DMV & FMCSA (MUTCD) — USA

What is this test? for New Hampshire DMV Cdl Combination permit/CDL, USA (MUTCD) — DMV — New Hampshire (USA, State Traffic Law) level, USA — New Hampshire.
Is this for you? For driver candidates in New Hampshire, USA — Cdl Combination permit/CDL (16+, State DMV)
Section: DMV New Hampshire — Cdl Combination · Education: High School & Adult (16+) · Part: DMV New Hampshire — Cdl Combination · Country: USA · Region: USA — New Hampshire

The DMV written test is an important step measuring driver candidates' knowledge of traffic laws, first aid, and vehicle technology.

This test reinforces your theoretical knowledge and provides the fundamentals needed to pass the exam and become a safe driver.

By solving this test of 20 questions, you can both test your knowledge and identify the topics you need to improve.

Question 1

In New Hampshire, what is a lowboy trailer?

A) van

B) food trailer

C) tanker

D) low deck for heavy equipment

Question 2

In New Hampshire, how secure converter dolly?

A) safety chains, lights connected

B) no lights

C) fast tow

D) loose tow

Question 3

In New Hampshire, what is kingpin inspection?

A) grease amount

B) brand

C) paint color

D) not bent, cracks, locked

Question 4

In New Hampshire, what gap between fifth wheel?

A) any gap

B) 1 inch ok

C) no gap (tight coupling)

D) not checked

Question 5

In New Hampshire, how uncouple safely?

A) fast pull

B) level ground, brakes set, lower gear first

C) any slope

D) no brakes

Question 6

In New Hampshire, what is trailer ABS light for?

A) shows trailer ABS fault

B) turn signal

C) brake lights

D) decoration

Question 7

In New Hampshire, how test ABS?

A) no test

B) drive test

C) ask others

D) watch dash + trailer lamp at startup

Question 8

In New Hampshire, what is landing gear position?

A) down always

B) dragging fine

C) half down ok

D) fully raised for travel

Question 9

In New Hampshire, how cross railroad with doubles?

A) stop on tracks

B) know clearance, never stop on tracks

C) race gates

D) shift on tracks

Question 10

In New Hampshire, what following distance for combos?

A) 2 seconds

B) no rule

C) tailgate

D) 6+ seconds at speed

Question 11

In New Hampshire, what are trailer brakes types?

A) one type

B) no trailer brakes

C) service, emergency, parking

D) hand only

Question 12

In New Hampshire, how check air lines on doubles?

A) tug hard

B) visual only

C) no check

D) connected, sealed, no leaks or tangles

Question 13

In New Hampshire, what is a tractor protection valve?

A) horn

B) keeps tractor air if trailer breaks away

C) fuel valve

D) light switch

Question 14

In New Hampshire, how test tractor protection?

A) no test

B) ask others

C) pull trailer supply, check tractor brakes hold

D) drive test

Question 15

In New Hampshire, what is bobtailing?

A) backing

B) with doubles

C) driving tractor without trailer

D) parking

Question 16

True or false in New Hampshire: tractor plus trailer(s).

A) True

B) False

Question 17

True or false in New Hampshire: device coupling doubles.

A) True

B) False

Question 18

True or false in New Hampshire: rear trailer, dolly, front trailer in order.

A) True

B) False

Question 19

True or false in New Hampshire: rear trailer swings in turns.

A) True

B) False

Question 20

True or false in New Hampshire: slow well below curve speed.

A) True

B) False

US New Hampshire DMV CDL Combination Vehicles Test 2

Test Complete

About This Test